IoT-LAB_M3
- Alaeddine Weslati
- Keoma Brun
- Thomas Watteyne
Owned by Alaeddine Weslati
Project Leads
The IoT-LAB_M3 mote is based on a STM32 (ARM Cortex M3) micro-controller, and features a set of sensors and a radio interface.
OpenWSN support
The IoT-LAB_M3 is fully supported in OpenWSN.
The OpenWSN builders build the IoT-LAB_M3 firmware nightly:
Components
| MCU | ST2M32F103REY – 32-bits, 64kB RAM |
| sensors |
|
| external memory | 128 Mbits external Nor flash (N25Q128A13E1240F) |
| power | 3,7V LiPo battery – 650 mAh (063040) |
| radio chipset | AT86RF231 a IEEE802.15.4-compliant radio at 2.4 GHz |
| leds | green, red, orange |
Layout
Details
The M3 Open Node can reset, debug and program the STM32 on JTAG through the FTDI4232H connected to the USB. This component allows also a UART link to the STM32. The Open Node connector gives access to 3 STM32/GPIO and the STM32/I2C. Two power lines are accessible on this connector:
- a + 5.0 volts for the board power supply
- a 3.3 volts for the consumption monitoring of the STM32, the RF component and the sensors
The M3 Open Node can be used standalone without a gateway connected to the M3 Open node connector. The powering of the board is then assumed by a battery or by the USB connector The choice of the power input is done electronically (power management).
