OpenWSN support
The TelosB is fully supported in OpenWSN.
The OpenWSN builders build the TelosB firmware nightly:
Overview
- Buy from MEMSIC, or see the Advanticsys CM5000 clone
- MSP430f1611, 48kB flash, 10kB RAM
- CC2420
JTAG support
- Remove the battery holder (cut the two wires)
- Solder a 4x1 2mm pitch female header on
U8 - Buy or build a JTAG adaptor board
- Buy a debugger, like the TI MSP-430FETUIF
| There are no images attached to this page. |
Stencil
Download the stencil in visio format here or in pdf here.
Datasheets
No files shared here yet.
